Strain Gauge or Load Cell Indicator | ...
The PSD232 is fitted with a 8 pin connector which allows users to connect the appropriate cabling for their application.
As with the standard PSD handheld, the PSD232 weighs only 250 grams and has a 7 digit LCD display with 6 tactile push buttons for access to on/off, gross/net, peak, trough, display hold and shunt cal functions. The indicator is micro processor based designed to interface with any full bridge sensor with an output sensitivity of up to 50mV/V. Bridge resistances from 85 ohms upwards can be used.
Two units of measure are able to be read and displayed such as kg & lbs. An annunciator indicates which range has been selected and there is a window, to insert a legend, describing each unit of measure.
The menu options accessed via the tactile keypad offers the ability to tailor the instruments response to the application including configuring the display update rate to either 0.5Hz, 1 Hz, 3Hz or 10Hz, setting auto power down, and overload. Calibration is also performed from the menu. Up to 450 hours battery life can be achieved whilst in power save mode with powering via 2 x AA Alkaline batteries (not included). An auto sleep/off function can be set ranging from 1 minute up to 99 minutes.
Both PSD's are TEDS 'Plug and Play' (Transducer Electronic Data Sheets) enabled.
1 year warranty with accessory options of a black leather carry case with shoulder strap which allows full operation of the PSD232 whilst being carried in the case.
The Case is Registered Design No. 3021311
To view more information including product specifications please click here.
To contact Applied Measurement Australia about Strain Gauge or Load Cell Indicator | PSD232 -RS232 Interface use Get a quote.
The PSD232 is fitted with a 8 pin connector which allows users to connect the appropriate cabling for their application.
As with the standard PSD handheld, the PSD232 weighs only 250 grams and has a 7 digit LCD display with 6 tactile push buttons for access to on/off, gross/net, peak, trough, display hold and shunt cal functions. The indicator is micro processor based designed to interface with any full bridge sensor with an output sensitivity of up to 50mV/V. Bridge resistances from 85 ohms upwards can be used.
Two units of measure are able to be read and displayed such as kg & lbs. An annunciator indicates which range has been selected and there is a window, to insert a legend, describing each unit of measure.
The menu options accessed via the tactile keypad offers the ability to tailor the instruments response to the application including configuring the display update rate to either 0.5Hz, 1 Hz, 3Hz or 10Hz, setting auto power down, and overload. Calibration is also performed from the menu. Up to 450 hours battery life can be achieved whilst in power save mode with powering via 2 x AA Alkaline batteries (not included). An auto sleep/off function can be set ranging from 1 minute up to 99 minutes.
Both PSD's are TEDS 'Plug and Play' (Transducer Electronic Data Sheets) enabled.
1 year warranty with accessory options of a black leather carry case with shoulder strap which allows full operation of the PSD232 whilst being carried in the case.
The Case is Registered Design No. 3021311
To view more information including product specifications please click here.
To contact Applied Measurement Australia about Strain Gauge or Load Cell Indicator | PSD232 -RS232 Interface use Get a quote.
Thanks for your help!
Sorry! Unable to submit your request at this time. Please try again later.
Report this product